T 18V Cordless 2 Speed Drill Basic in Systainer
For quick changes between drilling and screwdriving
Enjoy full flexibility when drilling and screwdriving: the completely electronic torque adjustment, CENTROTEC quick-change system, as well as angle attachment, eccentric attachment and depth stop can handle any drilling or screwdriving task. The combination of the Li-HighPower battery pack and maintenance-free brushless EC-TEC motor means that the T 18+3 cordless drill is light, long-lasting and durable. The cordless screwdriver and battery pack are completely covered with the Festool SERVICE, giving you peace of mind for your day-to-day work. Available in T-design or – depending on personal preference – in the unique C-design as the C 18.
- Furniture assembly and kitchen fitting
- Installation of fittings, rear walls, strips
- Installation of doors and windows, and drilling and screwdriving in wood, metal and plastic
- Fences, pergolas, carports, canopies
- Production of wooden substructures
The brushless EC-TEC motor is wear-free and converts the energy from the battery into optimum power with virtually no losses. The electronic motor management also guarantees maximum service life: Microprocessors monitor and control the temperature, voltage and current consumption of the motor, electronics and battery.
The Li-HighPower Compact battery guarantees full power, while weighing considerably less. To provide even more endurance, the brushless and maintenance-free EC-TEC motor only takes as much power as required by each screwing task.
The light T-design, the slender SoftGrip handle and the perfectly located centre of gravity ensure that work goes particularly easily and smoothly.
As with all cordless drills from Festool, the bits can also be inserted in the direct bit holder of the spindle on the T 18.
The practical bit holder provides space for up to six bits – magnetically secured against falling out.
The angle attachment is perfect for work around corners and reaching concealed screws at tight angles.
Every screw can be reached with the eccentric adapter.
Fast change between drilling, countersinking and screwdriving: The CENTROTEC quick-change system is a chuck and bit holder in one and, at the same time, 50% smaller and 80% lighter than a standard drill chuck. The hexagonal tools are centred using balls – for optimised power transmission and ten times higher true running.
The chuck with a standard width of up to 13 mm also enables the use of all standard bits and drill bits. Tool-free mounting via the FastFix interface.
Fully electronic torque adjustment and shut-off for optimum power development in all situations. The torque setting for screwdriving is retained, even when drilling takes place at maximum torque.
The integrated LED light permits precise work even in dark corners.
- CENTROTEC Drill Chuck$41.50