Home
Promotions
Special Prices

Special Prices

Q4 Promotions · Special Prices

The parts that make it a system.

There isn’t a single tool on this page. What’s here are the parts that join the system together: the tool to the extractor, the saw to the cut, the abrasive to the surface, the kit to the van.

Festool accessories and consumables on a workshop shelf: abrasives, guide rail parts and Systainer storage

6 → 3

discs to sand 12 lineal metres of fascia or weatherboard at $80/hr. Jetstream extraction lifts the dust clear so the abrasive keeps cutting instead of clogging. That halves the abrasive on the same job, before any saving on the box.

Saw to cut

Guide rail accessories

Adjustable angle stop $319, 90° square $260, FS 150 one-handed clamp twin pack $89. Repeat angles without repeat mark-out, and a rail that stays where you put it.

Abrasive to surface

Granat Net Systainer sets

225 mm $299 for long-reach wall and ceiling work, 150 mm $199 for ROTEX and ETS. Graded, boxed and ready rather than a pile of loose discs.

Tool to van

Extraction and storage

Anti-static Plug-it hose 27 mm × 3 m $380, Systainer3 rack $215, SysRoll cart $269, SYS 2 medium $132. The connections between the tool, the extractor and the vehicle.

Special prices until 31/12/2026

Beech tenon starter Systainer, 4–10 mm: $390. The consumable that turns a DOMINO into a jointing system.
Granat Net Abrasive Systainer sets: 225 mm $299, 150 mm $199.
Guide rail system: adjustable angle stop $319, 90° square $260, FS 150 clamp twin pack $89.
Anti-static Plug-it suction hose, 27 mm × 3 m: $380.
Storage: Systainer3 rack $215, SysRoll mobile cart $269, Systainer3 SYS 2 medium $132.
Centrotec bit set in Systainer3: $299. Spirit level $115.

Pairs with: Painter · Cabinet Maker · Builder

All prices AUD and GST inclusive. Special prices valid 01/10/2026 – 31/12/2026 or while stocks last. Abrasive figures are indicative, based on the scenario stated at the labour rate shown.