Fine Tooth Saw Blade 254mm x 2.4mm x 30mm 60 Tooth

Functions

A 254mm Festool Fine Tooth saw blade for clean, finish-grade cuts in wood, wood-based panels and hard plastics — the cabinet shop's go-to blade when chip-out is the enemy. With a 30mm bore, 2.4mm kerf and 60 teeth in the yellow-coded Wood family, this blade is sized for use on the TKS 80 table saw. Use this blade when finish quality matters: veneered panels (where the visible face leaves no margin for chip-out), parquet, solid wood cross cuts, blockboard, plywood, multiplex and multi-layered timber, MDF (medium-density fibreboard), HDF (high-density fibreboard), hard plastic, hard PVC and acrylic glass. The 60-tooth count and W Top Bevel tooth geometry sever the cut cleanly through the surface fibres on both faces of the panel, leaving an edge fine enough to assemble without further dressing. Like all standard and fine-tooth Festool blades, this blade can be resharpened up to six times, significantly extending blade life and reducing cost-per-cut. The high-quality steel body and fine-grain carbide teeth are engineered to hold the precision tolerances finish work demands — a blade that runs true cut after cut, not a blade that drifts as it heats up. A genuine Festool blade, ground and balanced to the original specification of the TKS 80. For full saw and material compatibility, the Which Saw Blade? guide is available in the Saw Advice Hub, accessible from the Saws section on festool.com.au.