Edge Trimming Cutter HW S8 D12.7/NL25

Functions

A 12.7mm diameter, 25mm cutting length carbide (HW) edge trimming cutter with an 8mm shank and ball bearing guide. Designed for flush trimming where a longer cutting length is needed — the 25mm cut handles thicker overlays, applied veneers and built-up edges that shorter cutters cannot trim in a single pass. Use this cutter when the work demands the extended cutting length: flush-trimming thick edge bands, multi-ply veneer applications, applied moulded edges, or repeated trimming passes that need a continuous unbroken cut line. The ball bearing guide rides the substrate edge and holds the cutter on a consistent reference, while the longer cutting flute removes the overlay cleanly without leaving step marks where shorter cutters would need multiple passes. A genuine Festool carbide cutter, manufactured to the specification of the Festool router and trimmer systems that accept 8mm shank cutters. Cabinetmakers, joiners, shopfitters and laminate fabricators choose the genuine Festool cutters for the longer-reach flush trimming work because consistent geometry over a 25mm cutting length is what separates a clean single-pass trim from a multi-pass trim that leaves visible witness lines.