Aluminium Saw Blade 254mm x2.4mm x 30mm 80 Tooth

Functions

A 254mm Festool Aluminium saw blade for cutting non-ferrous metals and hard plastics in the workshop — the table-saw version of the work shopfitters and kitchen makers do every day. With a 30mm bore, 2.4mm kerf and 80 teeth in the blue-coded Aluminium family, this blade is sized for use on the TKS 80 table saw. Use this blade for the materials it was engineered for: aluminium panels 8–25mm thick, aluminium profiles, aluminium composite panels (ACP), non-ferrous metals such as copper and brass, hard plastic and hard PVC, acrylic glass, fibre-reinforced plastics, and phenolic resin bonded fibres and fabrics. The 80-tooth count and triple-chip-grind tooth geometry shear the cut cleanly without tearing or melting the workpiece, leaving an edge that needs little or no finishing — important when you're cutting ACP for a cladding or signage job and the visible edge is the finished edge. Like all standard and fine-tooth Festool blades, this blade can be resharpened up to six times, significantly extending blade life and reducing cost-per-cut over generic single-use alternatives. The fine-grain carbide teeth and laser-cut, thermally adjusted blade core minimise heat build-up during the cut, helping the blade hold true through the volume of cuts a workshop puts through a table saw. A genuine Festool blade, ground and balanced to the original specification of the TKS 80. For full saw and material compatibility, the Which Saw Blade? guide is available in the Saw Advice Hub, accessible from the Saws section on festool.com.au.